- Dec 19, 2017 -
1, we should invite experienced and qualified professionals to carry out construction and installation. When installed, the tap should avoid and hard knock, no cement, glue and other residues on the surface, so as not to damage the surface gloss of coating. Be careful to remove the debris from the pipe and put it on the faucet.
In 2, the water pressure is not less than 0.02MPa (0.2kgf / cm2) of the case, after a period of use, such as found in water is reduced, and even the water heater flameout phenomenon, the water outlet is at the head of the screen gently twist the cover, remove impurities, general can recover.
3, the switch faucet does not force too hard, the homeopathy can be gently rotated. Even the traditional faucet does not need to be screwed up very hard. In particular, do not use the handle as a handrail to support or use.
A metal hose 4, bathtub faucet should maintain the natural stretch of state, need not be coiled on the tap. At the same time, do not form a dead angle at the joint of the hose and body when used or not, so as not to break or damage the hose.
- What is the most appropriate height...
- Three-point quality faucet
- Faucet the correct way to buy
- Faucet installation method
- Selection techniques of the faucet
- How to choose the quality of the fa...
- Valve knowledge: ball valve
- Faucet cleaning and maintenance
- Types of faucets
- Shower faucet selection method of p...
- A Single Function Cartridge
- Cermaic Cartridge
- Ceramic Cartridge Second Section
- Ceramic Chip
- Friendly Reminder About Cartridge
- Thermostatic cartridge
Related Industry Knowledge