How To Install Basin Faucets To Achieve Water-saving Effect

- Dec 19, 2017 -

The faucet is a necessary product of the kitchen and toilet, and we can't measure it by size. But everything is a double-edged sword, which brings convenience and a lot of trouble. The failure of the faucet is largely not the only quality decision of the faucet manufacturer, and its installation module also occupies a small position.

The faucet manufacturers require that the installation of Single Hole Kitchen Faucet should be stable, because the kitchen faucets are frequently used frequently, and they are easily moved and moved, so the locknut must be tightened. Now, there are some faucet manufacturers on the market, which are fixed by screw pipes and nuts. The effect is very good. If we can solve the problem of water lifting, it will become a popular trend in the future.

Tap faucet manufacturer installation should pay attention to the nozzle diameter, now on the market most are hard pipe water, so you should pay attention to reserve the nozzle height, 35 cm from the basin down the most appropriate.  When installing, a special angle valve must be selected, and the angle valve must be fixed with the cold and hot water pipe of the wall.

When you find a distance between the angle valve and the water pipe on the faucet, you must buy a special lengthening tube to connect. Never use other water pipes to connect, because if the water pressure is large, it will easily fall off and leak, and it will cause losses to you. If the water inlet pipe is too long over water, according to your needs take part, angle of inappropriate words according to the need to moderate bend to your desired position. Do not bend hard to 90 degrees or more than 90 degrees. When installing the basin to water, please don't forget the small interface to buy the faucet at the faucet factory. Before you install it, please don't forget to get the water pipe buried in the wall ahead of time.

Before installing the thermostatic faucet, please check whether the water pipe is left hot and right cold. Do not connect the hot and cold water pipes, so that the faucet will not work properly. The gas and solar water heaters can't use the thermostat of the faucet manufacturer, because the water pressure is too low. Install the constant temperature faucet, please do not forget to install the cold and hot water filter.